Page 4 of 7
Re: BlackSheep's choice...
Posted: Thu Nov 11, 2021 6:58 pm
by BlackSheep214
Progress last night...
Masked the canopy...
Test fitting lower to upper wing section to line up and hold glued cockpit floor in place
Nose machine gun assembly...
Re: BlackSheep's choice...
Posted: Fri Nov 12, 2021 8:04 pm
by BlackSheep214
Progress November 12, 2021
Cowlings installed on twin booms
MGs painted Gunmetal
Rear radar man in place, MGs installed (snapped in place - not glued)
The reasoning why I simply "snapped" MGs panel in place to make it easy to line up the barrel holes on the nose cone. Pics forthcoming tomorrow...
Nose panels closed up!!
Re: BlackSheep's choice...
Posted: Fri Nov 12, 2021 8:08 pm
by LyleW
That is coming along swimmingly! Looks great, too!
Re: BlackSheep's choice...
Posted: Fri Nov 12, 2021 8:25 pm
by Ceaser_Sa1ad
Nice work!
Re: BlackSheep's choice...
Posted: Sat Nov 13, 2021 12:27 pm
by BlackSheep214
Thanks Lyle & Declan!!
Morning progress!!
Here's the reason why I chose to "snap' in place the MG panel. It gives me some easy wiggle room to line up each gun barrel to the gun barrel holes in the nose....
Twin booms, tail rudders and nose radome installed!!
Almost ready for paint! Just got a few fiddly bits to glue on.
I'm debating on whether to use Semi Gloss or Satin Black for this one. Thoughts?
Re: BlackSheep's choice...
Posted: Sat Nov 13, 2021 12:37 pm
by keavdog
Wow - lot's of progress. How are you going to finish her? These were all in black no?
Re: BlackSheep's choice...
Posted: Sat Nov 13, 2021 12:39 pm
by BlackSheep214
All black.
Re: BlackSheep's choice...
Posted: Sat Nov 13, 2021 1:42 pm
by Ceaser_Sa1ad
Looks great! That is a lot of progress already. Way to go
I have to do one of these sometime.
Re: BlackSheep's choice...
Posted: Thu Nov 18, 2021 10:27 am
by Stuart
Great bit of work there Tom.
Personally I'd go for matt, but it might well look good in Satin.
Re: BlackSheep's choice...
Posted: Fri Nov 26, 2021 5:03 pm
by BlackSheep214
Tail rudder and underwing fiddly bits on and started painting semi-gloss paint using decanted Rustoleum Semi-gloss black. Pics forthcoming...
It was my first time decanting from a rattlecan. Simple, yet a little messy somewhat.
I'm looking to shoot the SG black then shoot decanted Rustoleum satin Canyon Black lightly as final coat before decaling.