Page 4 of 6
Re: Kitty Hawk 1/48 UH-1D Huey
Posted: Sun Apr 25, 2021 1:45 pm
by Stikpusher
And off we go!
Re: Kitty Hawk 1/48 UH-1D Huey
Posted: Sun Apr 25, 2021 3:53 pm
by Paul
I was enjoying building this kit, that is until I got to the rotor head where I boffed the entire assrmbly.
Re: Kitty Hawk 1/48 UH-1D Huey
Posted: Wed Apr 28, 2021 3:56 am
by mustang1989
YESS! Looking forward to seeing this one go together.
Re: Kitty Hawk 1/48 UH-1D Huey
Posted: Sun May 09, 2021 12:01 pm
by midnightprowler
A little more painting done.
Will be using this with the PE in the kit.
Re: Kitty Hawk 1/48 UH-1D Huey
Posted: Sun May 09, 2021 3:07 pm
by mostrich
Just a couple of issues I ran into during my (yet unfinished) build.
The alignment bars on the inside of the gear housing shown in the instructions doesn't exist on the parts.
But the exact positioning of the base plate of the rotor head is super important. There's a slight angle involved that leads to a slightly tilted rotor head.
The instructions also suggest molded details on the upper cockpit panel. Ridiculous. But for placing the PE you'd have to grind it down anyways so no loss for you.
Re: Kitty Hawk 1/48 UH-1D Huey
Posted: Tue May 11, 2021 4:24 pm
by midnightprowler
Correct on all counts. Mine did however have the supports in the correct height for the transmission plate.
Re: Kitty Hawk 1/48 UH-1D Huey
Posted: Wed May 12, 2021 12:58 am
by mostrich
Okay then. So they seem to have revisited the parts. Not bad!
Re: Kitty Hawk 1/48 UH-1D Huey
Posted: Wed May 12, 2021 4:38 am
by mustang1989
Gonna have to keep these key points in mind for mine when I get to it. Yes....the mast assy is tilted forward just a tad. Off to a good start here Lee!!
Re: Kitty Hawk 1/48 UH-1D Huey
Posted: Sat May 15, 2021 12:11 pm
by midnightprowler
Re: Kitty Hawk 1/48 UH-1D Huey
Posted: Sun May 16, 2021 10:05 am
by midnightprowler