SPA Modeler

A 3d print that I just took off the printer and will be working on it on the side.
Geralt of Rivia, The White Wolf, Witcher

Looks good Clint, the printing quality is excellent!

What is actually the specs for your 3D printer, how many layers / inch (or cm) ?

- Kari

Thank you Kari. The printer is a Elegoo Mars with a printing resolution of 1440x2560 pixels
This was printed with a layer height of .05mm the torso was 1233 layers it was printed at the same time as the legs that was 734 layers tall for both pieces it took around 4.5hrs to print
build log will be here
http://www.spamodeler.com/forum/viewtop ... 02#p118502

Nice work!

Got both Super Hornets on the bench.

The Super Hornets look good! Talk about “Murder Hornets”...

Aside from working on my Camel today, I decided to repair this oldie, my first adult armor build, the old Tamiya M60A1 that I built when I was an 18 year old Private. It has been damaged and repaired over the years, and during this last move the antennas were lost and the bustle rack and the left side turret grab rail broken off. I repaired those items today, drilled out the antenna mounts, and added two steel wire antennas. They will not break off again the way that I installed them...

Big Witcher fan here. I would love to have one of those. I think a 3D printer is in my near future.


That looks very good indeed.

KSaarni wrote:Looks good Clint, the printing quality is excellent!

What is actually the specs for your 3D printer, how many layers / inch (or cm) ?

- Kari

I think I need one of those printers!

Nice looking hornets Mike!
Carlos I'm sure I could break, I think breaking antenna is the thing I'm best at.
John and Dragline, a 3d printer is a lot of fun, I got so many ideas on what to print.

What software are you using to create the file?