Page 68 of 126
Re: What's on your work bench atm ?
Posted: Wed Dec 15, 2021 9:41 pm
by BlackSheep214
Medic on the Overachiever comment.....

Re: What's on your work bench atm ?
Posted: Thu Dec 16, 2021 10:07 am
by Stuart
Man Carlos, that looks awesome!
Re: What's on your work bench atm ?
Posted: Thu Dec 16, 2021 1:26 pm
by Stikpusher
TJ, Kari, John, Gary, and Stuart, thank you one and all. It’s good to be wrapping this one up!
Re: What's on your work bench atm ?
Posted: Tue Dec 21, 2021 10:49 am
by Medicman71
Stikpusher wrote:I’ve also been working on this one trying to get it over the finish line by end of the year… getting close…
Wash into all the panel lines
I think I can… I think I can…
That's awesome!!!
Re: What's on your work bench atm ?
Posted: Tue Dec 21, 2021 10:52 am
by Stikpusher
Thanks Mike. It’s a weak kit, and the photos make it look better than it is in person…

Re: What's on your work bench atm ?
Posted: Thu Dec 23, 2021 1:06 pm
by Stikpusher
Nearing the finish line now…. Undersides flat coated, landing gear and ordnance added…
I just need to add a few breakables to the topside, touch up paint from that as needed, do the flat coat there, and remove the masking. Just another couple of short sessions.
Re: What's on your work bench atm ?
Posted: Thu Dec 23, 2021 4:37 pm
by KSaarni
Looking good Carlos!
- Kari
Re: What's on your work bench atm ?
Posted: Thu Dec 23, 2021 5:55 pm
by LyleW
That looks very jetty, in a great way! Well done.
Re: What's on your work bench atm ?
Posted: Thu Dec 23, 2021 6:38 pm
by Stuart
That looks bloody awesome mate, for such a shoddy kit, you're making a great job of it!
Re: What's on your work bench atm ?
Posted: Thu Dec 23, 2021 8:05 pm
by Stikpusher
Kari, Lyle, and Stuart, thank you.
LyleW wrote:That looks very jetty, in a great way! Well done.
Ya know, the 21 does indeed have some classic jet “lines”, so to speak.
Stuart wrote:That looks bloody awesome mate, for such a shoddy kit, you're making a great job of it!
It is indeed a shoddy kit. Up close I see all the kit flaws. But if you know nothing about the type, it looks ok.
Final update for the evening… Last breakable bits glued into place- the nose probe and the antenna on the spine.
Next is touch up paint as needed, flat coat, pull off the canopy masking and finito!