Eduard 1/48 Bf 109G-6/R6
Posted: Sat Jan 23, 2021 3:49 am
The finished Eduard Bf 109G-6/R6 Wilde Sau flown by Arnold Doring of 2. Staffel/JG 300
Figure was from a ICM kit
The German Shepard can be found here https://www.thingiverse.com/thing:1430214
This was a really fun build and I learned a lot about video editing while doing it.
The base was built from foam, 1/2" plywood and a oak boarder. My friend, who's been laser engraving the base's, did so again.
Woodland Scenics grasses and Vallejo thick mud was used for the ground work and the hard stand was made from balsa cut into strips.
The German Shepard was 3d printed on my Elegoo Mars resin printer.
Building of the base
I hope you guys enjoyed this one! I had a lot of fun building it.
Thanks for looking in!
Skol!
Figure was from a ICM kit
The German Shepard can be found here https://www.thingiverse.com/thing:1430214
This was a really fun build and I learned a lot about video editing while doing it.
The base was built from foam, 1/2" plywood and a oak boarder. My friend, who's been laser engraving the base's, did so again.
Woodland Scenics grasses and Vallejo thick mud was used for the ground work and the hard stand was made from balsa cut into strips.
The German Shepard was 3d printed on my Elegoo Mars resin printer.
Building of the base
I hope you guys enjoyed this one! I had a lot of fun building it.
Thanks for looking in!
Skol!