Dora Wings 1/48 Granville P-45B (Gee Bee with attitude)
Posted: Thu Jul 21, 2022 7:23 am
Okay the 1/32 Gee Bee isn't huge. I knew this one would be smaller but I just started laughing when I opened it. It is tiny. But first...
Arrived yesterday from the Ukraine - from the Plastic-Model-Store.com. Service was good and delivery wasn't bad at all. I had to sign for it when it arrived. Kind of unusual. But, given the current state of affairs in the Ukraine, maybe not so much. The kit arrived in a poofy kraft envelope. That got my attention. Upon opening, the box was "undone" and flattened and the sprues were inside a bubble wrap envelope of sorts. Well protected. So, I've reassembled the box and all rests comfortably therein.
Inside was a small flyer. Interesting to read.
Anyway, here are the contents. It has masks, resin (don't know why) and a PE fret...on something just over 4 inches long. I give you the KILLER BEE! 112mm long, 160mm wingspan, 56 parts, 20 PE parts.
resin stuff - cowling bump outs and gun barrels
decals
PE and paint mask (I think)
Sprues
and the clear sprue...one part
My plan (right) is to tackle this one after finishing the three racers. So, this should be started in 1-4 years.
Arrived yesterday from the Ukraine - from the Plastic-Model-Store.com. Service was good and delivery wasn't bad at all. I had to sign for it when it arrived. Kind of unusual. But, given the current state of affairs in the Ukraine, maybe not so much. The kit arrived in a poofy kraft envelope. That got my attention. Upon opening, the box was "undone" and flattened and the sprues were inside a bubble wrap envelope of sorts. Well protected. So, I've reassembled the box and all rests comfortably therein.
Inside was a small flyer. Interesting to read.
Anyway, here are the contents. It has masks, resin (don't know why) and a PE fret...on something just over 4 inches long. I give you the KILLER BEE! 112mm long, 160mm wingspan, 56 parts, 20 PE parts.
resin stuff - cowling bump outs and gun barrels
decals
PE and paint mask (I think)
Sprues
and the clear sprue...one part
My plan (right) is to tackle this one after finishing the three racers. So, this should be started in 1-4 years.