If this isn't the right place - feel free to move
It's big
Step 1 complete
Teching 1/6 5 cylinder radial engine COMPLETE
Teching 1/6 5 cylinder radial engine COMPLETE
Last edited by keavdog on Thu Apr 11, 2024 3:05 pm, edited 1 time in total.
Thanks,
John
John
Re: Teching 1/6 5 cylinder radial engine
Stopping for the night. Heads and cylinders are next. One of those projects that is hard to stop once you get going
Thanks,
John
John
- BlackSheep214
- Elite Member
- Posts: 10553
- Joined: Sun Apr 06, 2014 8:47 pm
Re: Teching 1/6 5 cylinder radial engine
Looks like a fun kit I’d do.
“Who controls the skies, controls the fate of this Earth”
Author unknown- 352nd Fighter Group, Blue-Nosed Bastards of Bodney
“Send one plane it’s a sortie; send two planes it’s a flight; send four planes it’s a test of airpower. - Richard Kohn
Author unknown- 352nd Fighter Group, Blue-Nosed Bastards of Bodney
“Send one plane it’s a sortie; send two planes it’s a flight; send four planes it’s a test of airpower. - Richard Kohn
Re: Teching 1/6 5 cylinder radial engine
Cool - looks like it could be a fun little teaching aid for engineering students.
Stuart Templeton 'I may not be good but I'm slow...'
My blog: https://stuartsscalemodels.blogspot.com/
My blog: https://stuartsscalemodels.blogspot.com/
Re: Teching 1/6 5 cylinder radial engine
That is surely a significant piece of steel, wouh !
Where did you find this ?
- Kari
Where did you find this ?
- Kari
---
On the bench:
Tamiya F-4B Phantom II 1/48
Kinetic F-16A (new tool) 1/48
https://www.facebook.com/GrundAsk-Scale ... 721218708/
On the bench:
Tamiya F-4B Phantom II 1/48
Kinetic F-16A (new tool) 1/48
https://www.facebook.com/GrundAsk-Scale ... 721218708/
Re: Teching 1/6 5 cylinder radial engine
I've learned a bit about radial engines for sure.
I got the kit from MicroMark. I've seen it and a couple others in their flyer for the past couple months and finally pulled the trigger.
I got the kit from MicroMark. I've seen it and a couple others in their flyer for the past couple months and finally pulled the trigger.
Thanks,
John
John
- Medicman71
- Elite Member
- Posts: 9823
- Joined: Mon Apr 07, 2014 9:32 am
- Location: Houston, Tx
Re: Teching 1/6 5 cylinder radial engine
That's really cool!
Mike
Sponsored by Boeing, Lockheed Martin, Northrop Grumman, Saab, BAE, and Dassault
Sponsored by Boeing, Lockheed Martin, Northrop Grumman, Saab, BAE, and Dassault
Re: Teching 1/6 5 cylinder radial engine
But, it would be super-cooper cool if it were the R-4350…..
To make each build less crappy than the last one. Or, put another way, "Better than the last one, not as good as the next one!"..
Re: Teching 1/6 5 cylinder radial engine
Once cylinder head done, 4 to go. Note the rocker arms over the functioning valves
Thanks,
John
John